Hero Passion X-Pro: Fixing Starter Motor Nut

[kenlitting]

Dear guys i had to remove nuts of starter motor my hero passion xpro bike for just exposing the engine fin showing signs of rust to be repainted by a spray can. Now tried fixing back the nut but it seems fixed by some adhesive sealant. What sealant to use to fix the nut back. Please see picture attached.

 

[Suryaputhra]

Does not look like threads in housing, may be nut inside motor assembly. You need to remove it and tight it using T Rod and open side with bit. Are these bolts holding motor to chassis frame. Full picture helpful.

 

[kenlitting]

Does not look like threads in housing, may be nut inside motor assembly. You need to remove it and tight it using T Rod and open side with bit. Are these bolts holding motor to chassis frame. Full picture helpful.

No the nut has a thread but it does not get tight seems like fixed with sealant. thread does not seem to be worn out just removed fiirst time.

 

[Suryaputhra]

No the nut has a thread but it does not get tight seems like fixed with sealant. thread does not seem to be worn out just removed fiirst time.

Where is the location of the nut, you can measure the pitch of the nut and try right size bolt. Anabond sells three types of thread lockers, blue one is removable red one permanent locker, you can try blue one available online.

 

[kenlitting]

Where is the location of the nut, you can measure the pitch of the nut and try right size bolt. Anabond sells three types of thread lockers, blue one is removable red one permanent locker, you can try blue one available online.

ok shall try

 

[deville_56]

Seems it hold something inside the cover. Mounting holes are on the other side.