Originally Posted by dileep
Please help me.
This is my story. I am owing a new swift VXi which i bought last year. It has completed just 4680Kms and also third service.
But i started to notice one issue when i crossed some 4400 Kms, the issue is When i change gear from 1 to 2 i can feel continuous jerking on clutch pedal as well as in the car body.From 2nd on wards it is fine.
i informed this to Maruthi dealer when i have given it for service then they said they will adjust the clutch. But that didnt resolve the issue. Early i used to face the issue when i run with AC. But now it is happening even without AC.
Again i took the car to the centr asked them to check , they agreed that there is some jerkingand they couldn't figure it out and said i am the first one reporting this issue...
My cars warrenty is not over yet..
What will i do now...Have any of you faced\heard this problem??? Was there any solution?
Hi dileep, at 4400kms
This is not a small issue.
Sue the service center guys,
Tell them to invite engineer's form maruthi Suzuki, which they will incase the service center guys dont know the issue.
As your car in warranty , you can boldly ask them to check the issue and must resolve it!!!!!!! Without damaging the car.
Mostly service guys end up repairing car rather than getting it right, they find something may be cause,which would not, they tighten it or change it unnecessarily, waste time.
Let them invite engineers from suzuki to solve issue rather than fixing it by them self.
Just in case take to some good local mechanic And ask him what would have been the issue, and give him a tip.
And make knowledge of it
For Ac issue.
Check compressor pressue using guage, will be in service center.
If its good
Proceed doing this.
Remove gas, remove compressor
Take in hand and rotate the pully, if bearing is gone, it will feel .
Just remove bearing from assembly
And source ut with some SKF bearing in market, replace and fill gas
Note , you can remove bearing without removing gas,
Just by removing belt and using some custom tools bearing can be removed.