Originally Posted by Bump_that
@superhornet : How did you made those angel eyes they look awesome and a ninja in green colour is always treat to my eyes
I Use small pieces of gel pen refill tubes to create angel eyes, these refills easily fit a 3mm LED inside them (projector light) And 5mm LED can be placed behind refill tube to create angel eyes like effect. 3mm LED must be covered with opaque material to avoid light bleeding when angel eye is turned on. I use silver foil to cover the Circumference of 3mm LED and chewing gum (gross but effective) to block its rear side.
Completing R1 and triumph daytona will take atleast 2 more months.
New Ray CBR1000RR repsol edition
3528 SMD (warm white) for Headlamps (X4), pilot lamps (X2), turn indicators (X4), number plate illuminator (X1)
5mm Red LEDs (2X) for tail lamp
3mm white LED (1X) for speedo backlight
RF controlled low/high beam and turn indicators
555 timer is used to blink turn signal LEDs (total two 555 timers, one for each side)
still work in progress. Will upgrade to arduino based setup with TV IR remote controlled lights, integrated battery and better wire management.
Please excluse my photography "skills".