Suzuki Access LED Lights

[Rishwanth]

I have changed my indicators lights with LED.
Bt the rear lights work properly, but the front LED do not work.
And the rear lights flash at a very high rate.
Please help me in fixin this problem.

 

[ak9888]

please change the non working one. its normal if rear is flashing at a high rate because one of the bulb is malfunctioning. it will start working fine as soon as you replace non working one.

 

[Rishwanth]

All lights are functioning properly, but thr thing is ly front 2 indicators are not working.
When the same front led is inserted to the rear ports, the work.
Only front ports are not working.
I read somewhere that polarity should be corrected incase of led lights.
What should i do??
i even replaced flasher! But still no use!!!

 

[puneet848]

First make sure access has Dc lighting. Ac lighting wont work on leds and they will go bad in a matter of days if you use on them. Indicators flash faster as the stock flasher is made for the halogen bulbs that consume more power. To get flashing rate same as stock on LED either get a Led flasher module or make a diode and resistor circuit so power consumption with present leds is same as with halogen and they flash at same rate.

 

[deville_56]

Stock flashers are load dependent. They need the stock rating load to function properly. Either get an electronic flasher relay (most cheaper ones are electronic) or connect a 10W resistor in parallel with each LED setup.